Troy Boardä Acoustical Sound Board

Troy Boardä structural acoustical boards are rugged, strong and waterproof. The natural components that make up the Troy Boardä material are impregnable to the exterior elements, thus enabling the use of this material for exterior applications as environmental sound control. This abuse resistant material is the ideal choice for shooting ranges, sound stages, equipment enclosures and highway noise barriers. Interior uses range from recording studios, test chambers and home theatres. 

The edges are trimmed to provide a bevel or square edge look. The tongue and grove shape provides snug fitting seams. The Troy Boardä may be cut with a “Skill Saw”, or “Sawzall” type of saw. No special cutting devises are necessary, although, carbide blades are preferred.

Interior Walls and Ceilings: Staggered seams are preferred, however for heights less than 8’, sheets may be run vertically. Fasteners: #14 self-tapping hex head-for steel connections, ¼” lag type screws for wood connections. Always use an approved dust mask and goggles when cutting and installation of Troy Boardä.

Expose Troy Boardä may be covered with fabric, for interior finishes, or painted using acrylic latex paint with an airless sprayer. No other finishes are necessary for acoustical absorption.

The Troy Board finish color is a primer white with the natural color of wood fibers blended through.

Troy Boardä does not contain any asbestos, urea-formaldehyde or CFC blowing agents.

Troy Boardä is listed with the New York City Board of Standards and Appeals- Calendar No. 651-73-SM

Available Dimension

Surface Burning Characteristics/ Building Code Construction Classification

Acoustical Performance

Troy Wool™ Acoustical Insulation

Installation

Troy Wool™ Acoustical Insulation is easily cut with a knife for quick installation and snug fit, even around obstruction and structural members. Butt ends and edges together closely to fill all voids with additional insulation.

            Interior walls: Friction fit Troy Wool™ Acoustical Insulation batts between metal or wood studs, filling the entire cavity to the full height of the wall. Leave no voids.

            Ceilings: Lay Troy Wool™ Acoustical Insulation batts over designated ceiling area. Stick clips may also be used over concrete decks.

            Do not expose product to weather during shipping, storage or installation. Use an approved dust respirator and goggles when handling and installation of Troy Wool™ Acoustical insulation. A loose fitting long-sleeved shirt and long pants are recommended to provide skin protection. Hat or caps keep dust particles out of hair and away from scalp.

Applicable Standards

Troy Wool™ Acoustical Insulation complies with ASTM C 665 Type I. The material is considered noncombustible per ASTM C 136. Troy Wool™ Acoustical Insulation also complies with the MEA 346-90 requirements of the City of New York.

Information on the surface burning characteristics of Troy Wool™ Acoustical Insulation was derived from product test per ASTM E 84. This standard is used to measure and describe the properties of materials, products or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or approve the fire hazard of materials under actual fire conditions. However, the results of these tests may be used as elements of a fire risk assessment that takes into account all of the factors pertinent to an assessment of the fire hazard of a particular end use. Values are reported to the nearest five (5) ratings.

Troy Wool™ Acoustical Insulation

Surface Burning Characteristics/ Building Code Construction Classification

Acoustical Performance

Thermal Performance

Manufactured exclusively for Troy Acoustics Corporation, by IIG, LLC